Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
macintosh_se [2018/09/15 01:03]
yehowshua
macintosh_se [2018/10/15 11:47] (current)
yehowshua
Line 1: Line 1:
-== First Steps ==+===== First Steps =====
 The first thing I always do is power on the device. The first thing I always do is power on the device.
  
Line 24: Line 24:
   * The SE uses a BBU which is essentially a very primitive MMU/bus arbiter   * The SE uses a BBU which is essentially a very primitive MMU/bus arbiter
  
-== Next Steps ==+===== Next Steps =====
   * [[Disassembling Macintosh SE Kernel/​Bootloader]]   * [[Disassembling Macintosh SE Kernel/​Bootloader]]
   * [[Reading Data and Address with a Logic Analyzer]]   * [[Reading Data and Address with a Logic Analyzer]]
Line 33: Line 33:
   * [[Using SUMP2 to probe Data and Address bus]]   * [[Using SUMP2 to probe Data and Address bus]]
  
-=== To Do List ===+====== To Do List ======
   * Remove CopyRighted Material and insert legal reproductions   * Remove CopyRighted Material and insert legal reproductions
   * Refresh Board   * Refresh Board
Line 47: Line 47:
   * Design PCB that house the HIGH and LOW roms and captures contents to verify.   * Design PCB that house the HIGH and LOW roms and captures contents to verify.
  
-=== If no success by this point: ===+====== If no success by this point: ​======
   * Determine Faulty component and replace - if not replaceable logic, wrtie FPGA implementation,​ reflow board, and seat FPGA into logic board.)   * Determine Faulty component and replace - if not replaceable logic, wrtie FPGA implementation,​ reflow board, and seat FPGA into logic board.)
  • /var/www/html/container/dokuwiki-2018-04-22a/data/pages/macintosh_se.txt
  • Last modified: 2018/10/15 11:47
  • by yehowshua